Carson Linde H40D, Instruction Manual

17 

//  

gb

bIndIng

Assigning a transmitter identifier to the 

receiver (binding)

When a remote control signal is sent, in addition to control infor-

mation, an electronic identifier is sent with each transmitter burst. 

This is how the receiver recognizes that the signal has come from 

its own transmitter. Since many millions of transmitter identifiers 

are available, it is extremely unlikely that a different transmitter 

could influence your receiver.
In case the (radio) connection between the transmitter and the 

model is lost, the assignment must be renewed. For this purpose, 

the following procedure is required. So far as possible, it should be 

undertaken at a place where no other electrical signal – especially 

from another 2.4-GHz transmitter – can interfere with this trans-

mission.

1.  With transmitter and model ready to operate but switched off, 

position them a short distance apart.

2.  Switch on the model. Press the “Setup/Binding” button; the LED 

should begin to flash.

3.  Now switch on the transmitter.
4.  When the receiver LED is lit continuously, the binding process is 

complete and the RC system is ready for use.

Setup button 

model

1. first switch on the transmitter.
2. no you’re ready to activate the model.
To do this, push the main switch (power) on the underside of the 

model to the ”ON” position.
If the wheels start to turn, trim them in the opposite direction 

using the throttle trim.

The engine and warning sounds can also be switched on using a 

separate switch.
To switch off after use, switch the model off, and then the 

transmitter.

Start

OFF 

ON

OFF 

ON

OFF 

ON

Engine 

sounds

Power

Warning 

sounds

ON

OFF

2

1