CARSON Reflex Stick Ultimate Touch 500501002
104
GB
This function enables the user to select five different
conditions for the model.
This function can set the flight condition and there
are 5 conditions at most. The default name is Normal,
Take off, High speed 3D flight, Landing, which can
be amended. C2 - C5 can be assigned to one switch
to be turned on or off and can be copied (excluding
the switches you set). After setting parameter of one
condition, you can copy it to create a new one and
then sub trim it, which can help you save setting
time. No assigned switches are set by default. So C1
is the default and C2-C5 is off.
When any other conditions are assigned to a switch,
it will be Normal condition after turning off this
switch.
The high level condition is available if assigning two
or more conditions at the same time. C5 is the hig-
hest level and C1 is the lowest level.
Select one condition and you can amend the con-
dition name, copy the condition and assign it to a
switch.
As shown in picture 21 .25: C2: Take off is selected.
Push the SWA downward to enable this function.
Pic. 21.25
Pic. 21.26
1.28 Conditions
