CARSON Reflex Stick Ultimate Touch 500501002
112
GB
This function is used to protect aircraft with parame-
ters set in advance when the receivers don´t receive
the signals. Press failsafe function and it will display
the current setting of 10 channels Off means that in
case of a loss of signal, the corresponding servo will
keep its last received position.. The servo will move
the position you preset .All the channel is able to be
set failsafe.
As shown in picture 21.502 Only CH2 Ele is set to
-50% in case of a loss of signal. The others will keep
their previous position.
Touch a channel to set its failsafe behavior. If activated, set the channel to the desired position using the cor-
responding channel switch, knob, logic switch or stick then while maintaining that position, touch the back
button. The position of the servo is then memorized.
If multiple channel failsafe are activated, set the channels to the desired position using the corresponding
channel switch, knob logic switch or stick then while maintaining that position, touch the back button. The
position of the servo is then memorized.
The failsafe on the channel 2 (elevator) and channel 4(rudder) are activated and set to -100%.
Pic. 21.50
Pic. 21.51
Pic. 21.54
Pic. 21.53
Pic. 21.52
1.39 Failsafe function
1.40 Setup failsafe
