CARSON Reflex Stick Ultimate Touch 500501002
88
GB
1. Connect all the components as described in the
operating instructions.
2. Switch on the transmitter by hold down the two
power buttons same time.
3. Connect the RX battery to the receiver or the
battery to the ESC.
4. The red LED on the receiver will light up and
confirm the receipt of a correct signal.
5. If the error rate is less than 5%, the receiver signal
is stable.
6. The RC system can now be used.
To switch off, proceed in reverse order. Switch off the
receiver first, then the transmitter.
Advice
Boot abnormal protection
If the screen looks like picture there is a system
problem. You must resolve the problem before
restarting the system
1. The switch is not reset.
(You need to push switch up.)
2. Throttle Stick (Push to lowest setting)
1.2 Switch on the RC system
Power
Power
LED
