GB
// 22
ATTENTIoN
Keep the transmitter and receiver not over 40 cm
apart when setting and binding.
Use the REV switch (TH REV + ST REV) to change
the direction of rotation.
LoW BATTERY ALARm
When the battery power is too low, cease
operation immediately.
tranSmitter HanDLing
A. Throttle Stick
B. Steering Stick
Forward/
Speed up
Neutral
Brake/
Slow down
Throttle Trim
Channel 2
Throttle Trim
Channel 1
FaiL SaFe aDjuStment
1. Set the throttle and the steering stick to the neutral position.
2. Turn on the transmitter and receiver.
3. Press the F/S SET button, the LED on the receiver will start to
flash.
4. Put the throttle trigger at the brake position, press the “F/S SET”
button, the LED should become solid.
5. For electric models, put the throttle trigger at the neutral posi-
tion when you are making the failsafe setting.
Reflex Stick Pro3:
As soon as the receiver/transmitter signal is interrupted, the
receiver switches into the preset throttle failsafe setting.
Push the throttle stick for running forward and pull it
for breaking and running backward.
Steering trim (St. trim)
Move the trim tab to adjust the Steering Servo to the neutral
position.
throttle trim (tH. trim)
Move the trim tab to adjust the Throttle Servo (or the Speed
Controller) to the neutral position.
Move the steering stick to the left or to the right
according to the intended direction.
Summary of Contents for Reflex Wheel Pro LCD 3
Page 30: ...30 Notizen Notes ...
Page 31: ...31 ...
