G
31
CARSON X4 Quadcopter 360 FPV WIFI 500507101
Change control mode - Modes 1 and 2
The control mode on the transmitter can be changed. You can
switch between Mode 1 and Mode 2. Push the trim slider to the
right to switch on the transmitter. You will hear a signal indicating
the change of mode.
Mode 1: Turn function to right control lever
Mode 2: Turn function to left control lever
Special function explanation
1. Low power warning
When the four indicator lights on the bottom of the quadcopter start to flicker, the battery is run-
ning out of charge. You should guide the copter down immediately to avoid crash landing.
2. Re-calibrating the gyro
After a hard landing or crash you can recalibrate the gyro. To do so, place the copter on a comple-
tely flat surface. Then push the left and right levers of the transmitter to the bottom right hand
corner for about 2-3 seconds until the LEDs stop flashing, as shown in the illustration on the right.
The copter is ready to fly again.
3. Acrobatic Flight (Flips and Loops)
When you are familiar with the basic operation, you can
do some awesome and exciting tricks and stunts! First of
all, fly the aircraft to a height of more than 3 meters, press
the stunt button switch on the rear right hand side of
the transmitter, then push the right control lever (in any
direction) to perform a 360 degree flip.
Throw launch
Experienced pilots can launch a quadcopter the cool way! Throw your copter into the air, making
sure that you've got sufficient clearance (approx. 3-5m) and pushing the throttle gently up. It will
automatically level out and hover smoothly in the sky. Throw launching is best done on a large lawn
or field.
