G
40
CARSON X8E Chassis 500409015 / 500409016
4S – Basic Settings
Throttle range setting (throttle range calibra-
tion)
In order to make the ESC fit the throttle range of your transmitter, you
must calibrate it for the following cases; otherwise the ESC cannot
work properly.
1) Begin to use a new ESC
2) Begin to use a new transmitter
3) Change the settings of neutral position of the throttle lever, the
ATV or EPA parameters, etc.
Note 1
The “SET” key of ESC is at the power switch (see picture).
Note 2
If you don’t release the “SET” key as soon as the red LED begins to
flash, the ESC will enter the program mode. In such case, please switch
off the ESC and re-calibrate the throttle range again as described.
Release the SET key as soon as the red LED flashes.
There need to be set 3 points. They are the end point of “forward”, the
end point of ”backward” and the neutral point. The following pictures
show how to set the throttle range with your transmitter.
A) Switch off the ESC and turn on the transmitter.
B) Hold the “SETUP”-key of the ESC and then switch on the ESC.
Release the “SETUP” key as soon as the red LED begins to flash.
C) Set the 3 points according to the steps.
1. The neutral point
Move the throttle lever at the neutral point, and then click the SET key.
The green LED flashes 1 time.
2. The end point of forward direction
Move the throttle lever at the end point of forward direction, and then
click the SET key, the green LED flashes 2 times..
3. The end point of backward direction
Move the throttle lever at the end point of backward direction, and
then click the SET key, the green LED flashes 3 times.
The throttle range is calibrated; the motor can be started after 3
seconds.
Hold the SET
key
Switch on
ESC
Press and hold
