8
9
3. p
rocedUreS
Place the
C20 S
on your Tripod by loosening the tie-down knob
⓱
under the Fluid Head and level using the illuminated spirit level
⓯
.
In low light conditions, press button for light.
Connect one or two Pan bars
❺
to the Fluid Head tightening the
lever
❼
on the Pan bar attachment and select your desired operating
angle. The telescopic Pan bar length can be adjusted via lever
❻
.
Insert Pan
❿
and Tilt
⓫
locks and check the sliding Camera plat-
form lock lever
❹
. Set horizontal lock
❸
in position “On”.
Open the Camera plate release lever
❶
completely to release the
Camera plate
❸
.
Remove the Camera plate
❸
from the sliding Camera platform
❷
by squeezing simultaneously Camera plate release lever
❶
and the
safety lever
❹
. Attach the Camera plate
❸
to the bottom of the
Camera and tighten the clamping screw to secure the Camera.
Lock the sliding platform lever
❹
, click the Camera into the quick
release sliding platform
❷
, the plate will lock into place.
Hold the Camera in horizontal position with the Pan bar
❺
and re-
lease the Tilt brake lever
❿
. Release the sliding platform lever
❹
and find the correct center of gravity (CG) position, by sliding the
Camera platform
❹
back and forth until you have achieved the cor-
rect balance. Fasten the sliding platform lock
❹
.
Set the Counterbalance system by turning the selector clockwise
❾
to appropriate tension. The Camera must stay at any Tilt angle. Even-
tually, fine-tune by adjusting the sliding plate
❷
.
Unlock the Pan lock lever
❿
and set the Fluid drag control by adjust-
ing Pan selector
⓬
.
Set position “
ON
” on the Tilt angle increase selector
❽
for a
+/- 65°
Tilt angle. In case an extra
5°
is needed, set the selector on “
OFF
” po-
sition, keeping in mind you are now working on the springs limit angle.
When the illuminated spirit level
⓯
fails it is time to replace the 9
volts battery
⓭
. Remove the battery cover.
The above set-up instructions are for the achievement of precise pan,
tilt and diagonal movements. To get optimum results from your
C20 S
the equipment set up is very important.
Minimum payload
7 Kg
15 lbs
Maximum payload
35 Kg
77 lbs
Weight
6,5 Kg
14.3 lbs
Bowl diameter
100 mm & 150mm optional
Fluid control
7 steps + 0
Counterbalance
7 steps + 0
Pan range
360°
Tilt range
+/- 65°
Temperature range
-40 / +60 °C -40 / +140 °F
4. S
pecIfIcatIonS
