11
5.3 d
IsInfeCtIon
p
roCess
!
Always operate the
UV-C LED BOXER
in a clean and dry location. Do not expose to
rain, humidity, saline water, sand or dust.
• Connect the power cable to the power connector
❺
.
• Connect the power supply to the main power or to a battery.
• Select ON on the main switch
❻
.
• To optimize the UVC LED efficiency let them run for a preliminary 5-minute cycle with no
equipment in the compartment, this will bring the transformers to the optimum operating tem-
perature.
• Open the upper lid with the 2 portholes. Place the objects to be disinfected on the grid. Do
not exceed the weight of 20 kg – 45 lbs.
• Place the Dosimeter card on the grid near the equipment
• Close the disinfection compartment repositioning the upper lid
⓬
Magnets will help to keep
the closed position.
• Set the time on the timer (as per 4.3), for COVID disinfection the recommended exposure of
22mJ/cm
2
can be achieved in 5 minutes.
• Activate the on/off switch
❹
, the red indicator will light up.
• Wait until the completion of the disinfection cycle, the red Led indicator will switch off.
• In case the compartment is opened before the completion of the disinfection cycle the LED
will switch off and the timer will reset to zero.
!
To ensure the correct disinfection process, the cycle of radiation has to be continuous.
In case of any interruption the cycle should be repeated entirely.
WARNING!
WARNING!
WARNING!
WARNING!
Summary of Contents for UV-C BOXER
Page 6: ...6 2 Component list...
