25
TECHNICAL DATA
Rated voltage:
12 V d.c.
idle speed:
5500/min
acoustic pressure level: L
PA
: 83 dB (A); K
PA
: 3dB
L
WA
: 94 dB (A) ; K
PA
: 3dB
Vibration: a
h
= 4.20 m/s
2
; k=1.5 m/s
2
clockwise/anticlockwise
rotation:
yes
Size of chuck:
10mm
max. Torque:
300Nm
battery block DL-12:
2000mAh (Li-ion)
Charger input:
100-240V AC
50-60Hz 30W
Charger output:
12.6V DC 1500mA
Charging time:
80 minutes
Measured vales according to EN 60 745-2-2 and
EN 60 745-1.
Warning:
The actual vibration value during use
of the machine may vary from that stated in the
instruction manual or by the manufacturer. This may
be caused by the following influencing factors that
should be noted before and during every use:
- Is the machine being used correctly
- Is the manner in which the material is being cut or
how is being processed correct.
- Is the machine’s condition in use OK
- Sharpness of cutting tool and correct cutting tool
- Are the handles or optional anti-vibration handles
mounted and are they firmly fixed to the body of
the machine. If you have an unpleasant feeling or
a discolouration of your skin on your hands while
using the machine interrupt your work immedi-
ately. Take sufficient breaks form your work. Not
observing sufficient breaks from your work can lead
to hand-arm-vibration syndrome. An assessment
should be made of the degree of stress resulting
from the work and use of the machine and breaks
from work taken accordingly. This can significantly
reduce the degree of stress over the entire wor-
king time. Keep the risks to which you are exposed
through vibrations to a minimum. Care for this ma-
chine in accordance with the instruction manual.
If the machine is employed/used in a regular basis,
you should contact your specialist dealer and
purchase anti-vibration accessories (handles).
Avoid using the machine at temperatures of t=10°C
or below. Prepare a work schedule that allows
vibration stress to be limited.
CLEANING AND MAINTENANCE
Switch off the on/off switch and remove the battery
before performing any cleaning work.
Cleaning
Keep protective devices, ventilation slits and motor
housing as clear of dust and dirt as possible. Wipe
of the device with a clean cloth or use low-pressure
compressed air to blow off the dust and dirt. We
recommend cleaning the device immediately after
each use. Clean the device on a regular basis with
a damp cloth and a little neutral soap. Do not use
any detergents or solvents as these may corrode the
plastic pasts of the device. Make sue that no water
can penetrate the inside of the device.
Maintenance
There are no parts inside the device requiring
maintenance.
REPAIRS
Only use accessories and replacement parts recom-
mended by the manufacturer. Should the device
malfunction – despite our quality controls and your
care – have repairs performed exclusively by an
authorised, qualified electrician.
