CARVIN ENGINEERING DATA
WG5
PG. 2
INTRODUCTION
The WG5 Wireless Guitar/Bass System is designed to give you the
wireless freedom you have been looking for and the simplicity to
make your life as a working musician easier. Compact design coupled
with an intuitive, easy set up makes going wireless an enjoyable
process.
BATTERY CHARGING
The WG5 Wireless Guitar/Bass System contains an internal lithium
re-chargeable battery for hours of continuous use. To charge
the battery, simply connect the included USB charging cable to
the transmitter and receiver and then connect to a standard USB
charging source. Typical charge times is 2 hours for a full charge.
When the system is low on charge, the ID LED will begin to flash.
OPERATION
Power On/Off: First, press and hold the POWER button on the
transmitter until the green ID LED turns on. Then press and hold the
POWER button on the receiver until the green ID LED turns on. To
turn the units off, hold down the POWER button until the green ID
LED turns off.
Channel Selection and Setup: The WG
5
default setting is Channel
1. To select a different channel, with the transmitter power on, press
the POWER button. You will see the CHARGE LED flash red: once for
Channel 1, twice for Channel 2, three times for Channel 3 and four
times for Channel 4. Select the desired channel then press and hold
PAIR on the transmitter until the ID LED flashes then press PAIR on
the receiver until the ID LED lights on both units are solid green.
Pairing the Receiver to the Transmitter: If both the transmitter and
receiver are turned on and the green ID LED is flashing on both units,
the receiver needs to be paired to the transmitter. To do this, hold
down the PAIR button on the receiver until the ID LED lights on both
units are solid green.
