E.4 THE SPAN CALIBRATION
In this MODE 4, "ULOAd" is shown on the display.
1. Press the "ON/OFF" key,
-> The display shows a count down 9 to 0. -> "LOAd" is shown on the display.
2.
Load a full weight on the platter gently.
3.
Press the "ON/OFF" key,
-> The display shows a count down again, -> The display shows "End" and be
blanked.
4. Remove a full load from the platter.
* If you want to quit this span calibration, press the "ZERO" key while either "ULOAd " "LOAd" is shown on the display.
With above operations, the span calibration is finished, and following
paragraph C. 5 guides to confirm the span and to do a fine trimming for
more accurate weighing.
However when fine trimming is not needed, press the "ZERO" key to skip following
MODE 5 and exit to normal mode.
E.5 CONFIRMATION OF THE SPAN(MODE 5)
This mode 5 is only available after a performance of previous span calibration(mode 4).
1. Press the "TARE" key,
-> The display shows the initial zero point.
2.
Press the "ZERO" key to read a span(net weight),
-> The display shows "0".
3.
Load a full weight on the platter gently.
Unless the display has 30,000 +-1, for more accurate weighing, perform fine trimming.
4. If a span is bigger than 30,000, press the "*" or "kg/lb" key twice for a decreasing and
less than 30,000, press the "*" or "kg/lb" key and touch the "TARE" key for an
increasing.
Whenever you press these keys, a count can be changed.
5.
At the end of fine trimming, press the "ON/OFF" key.
6.
Press the "ZERO" key to exit and enter to normal mode.
-> Weight display shows "Err 2", but actually this error message is not a real error, it prompts only return CAL switch to the normal
position.
7. Return the CAL switch to the normal position(initial position).
or
Summary of Contents for AD series
