B. REPLACEMENT OF THE ANALOG MODULE
B.1 REPLACEMENT OF THE ANALOG MODULE
B.I.I Remove platter and the upper case.
B.1.2 Take a main circuit board out on the body.
B.1.3 Desolder the analog module pins(ll points) on main board.
B.1.4 Replace the analog module(CAM 01) by a new one.
B. 1.5 Install a main board on the body.
B.1.6 Reassemble upper case and platter.
B.2 THE SPAN CALIBRATION FOR THE ANALOG MODULE
Refer to the SPAN CALIBRATION FROM REPAIR in the CHAPTER-III.
C. REPLACEMENT OF THE DIGITAL MODULE
C.1 REPLACEMENT OF THE DIGITAL MODULE
C.I.I Remove the platter and the upper case.
C.1.2 Take a main circuit board out on the body.
C.1.3 Desolder the digital module pins(48 points) on main board.
C. 1.4 Replace the digital module(CDM 01) by a new one.
C.1.5 Install a main board on the body.
C.1.6 Reassemble upper case and platter.
C.2 THE INPUT FOR THE DIGITAL MODULE
In the digital module, it has a nonvolatile memory and contains a factor for a digital span calculations and the weighing conditions. Therefore all those input
procedures must be performed. Refer to APPENDIX-I.
Summary of Contents for AD series
