12
3-2. Label Roll Core Switch
1. Pull the Label Roll Holder to
the topmost and lift the Label
Roll Core upward.
2. Turn the Label Roll Core
outward as the figure shows.
3. Whirl the Label Roll Core
back to the original position
1 Inch Core
A. When the lock hole of Label
Roll Core is on upper side, it
applies to 1” core.
B. When the lock hole of Label
Roll Core is on lower side, it
applies to 1.5” core
[Note]
You can also distinguish
it by the index on the Label Roll
Core as shown in figure
1.5 Inch Core
Summary of Contents for BP-DT-4
