CAS DL Series, Owner'S Manual

12

④

 Press the MODE key to 

have number increase. To 
move flash to next digit, press 
the TARE key. 

⑤

Press ZERO key to set up 

HIGH limit. The display shows 
"0.0" and you can change 
these numbers by pressing 
MODE key. If you want to move
to next digit you can go by 
pressing TARE key. 

⑥

If you set up HIGH limit you 

can go out by pressing ZERO 
key, and you can see "ENd" 
message shortly and "WL 
on" message on the display. 

⑦

If you set up HIGH limit and LOW limit incorrectly, "Err" will be shown on the display. 

Then you may need to set it up again. For example, LOW LIMIT=69.9 kg and HIGH 
LIMIT=79.9 kg this is incorrect setting because HIGH limit is lower than the LOW limit. 
When HIGH and LOW limit are set as the same or above maximum capacity it still shows "Err" message. 
 
 
 
 
 
 
 
 
 
 
 
 

⑧

 If you want to go back to the 

simple weighing mode just 
press MODE key twice. 

⑨

Suppose that the HIGH limit 

and LOW limit are set up as 
79.9kg and 69.9kg respectively. 
If the weight loaded is 2kg 
between HIGH and LOW limit 
the display shows "OK" and the 
scale continues to beep slowly. 
If the weight loaded is above 
79.9kg, HIGH limit, the scale 
continues to beep rapidly.