10
Take the new roll of labels and find the ending. Peel-off and discard about 3 labels. Place the label in the
scale and thread the backing through the appropriate places.
Please view the checkpoints on the diagram. Feed the backing paper over the Paper Pressure Shaft lifting
the Pressure Plate in order to place backing between the two (
①
); Feed the backing paper between the
two green Sensor Caps (
②
); under the Label Guide Roller making sure that the backing paper lies
between the two washers on the Label Guide Roller (
③
); feed the backing over the red Rubber Roller
and under the Print Head being careful not to touch the underside of the Print Head (
④
); over the Peel-off
Bar (
⑤
); under the Return roller(
⑥
); feed the backing under and around the Pick Up Spool(
⑦
).
Now Attach the Pick Up Spool Pin into the spool and turn it slowly counterclockwise in order to tighten
the backing paper.
Push the Print Head down in order to lock it back in place(
⑧
).
You will feel and hear it lock in place. Replace the printer covers. You have completed the label roll
installation. (See below fig.)
