23
1) To go to PROGRAM mode, press 1 by using numeric keys and MODE key.
2) The display shows: “PLU ”.
3) Press PRT/* key. The display shows: “PLUno 4000”.
The number in the UNIT PRICE display indicates the amount of empty PLUs ready to be programmed.
4) Type a PLU number you wish to program. Remember, this number must be between 1 and 4000.
5) Press PRT/* key. The display shows “iCodE”. Press PRT/* key. (If you do not wish to program an item
code, press the
v
key) Thedisplay shows “iCodE EntEr 0”.
6) Type the item code number. The item code can be from 1 to 999999. If you enter 0, item code will not
be printed on the label. (This number is used by the scanning device in order to reference PLU.
In most cases, the item code is programmed to be the same as the PLU number).
Press PRT/* key when you’re done.
7) The display shows “nAME”(The name field is composed of 2 lines of text. Each line can contain up to
30 characters. Name is commonly referred to as commodity name.)
8) Press PRT/* key. (If you do not wish to program name, press the
v
key) The display shows
“nAME 01.01”. The numbers in the unit price display represent the line number and character number
on which your cursor is at. The number to the left of the decimal is the line number you are on(01 to 02).
The number to the right is the number of the character position on which you are about to type(01 to 30).
9) Now type in the first line of text using the Alpha-numeric keypad on the left side.
If you want to type second line of text, press ENTER key. (To skip, press PRT/* key.)
