6
Step 5.
To hang the fan body in the canopy,
hold the fan body firmly and insert the nylon
ball into the canopy opening. Check that no
wires were pinched. Rotate the fan body until
the slot in the nylon ball engages the canopy
pin opposite the canopy hatch opening.
HANGING THE FAN
CANOPY
PIN
SLOT
BALL
DOWNROD & MOTOR COVER INSTALLATION
ALLEN SET SCREW
DOWNROD
&
BALL
ASSEMBLY
Preparation Step B.
Route the black and white
wires from the motor through the downrod and
ball assembly. Make certain that you do not
scrape the insulation.
Preparation Step C.
Using the provided allen
wrench, unscrew the allen set screw until it clears
the inside of the motor coupling. Screw the
downrod into the motor coupling until tight.
Preparation Step D.
Using the provided allen
wrench, tighten the allen set screw to ensure
safe operation of your fan.
MOTOR
COUPLING
TAPERED
THREAD
MOTOR
WIRES
GROUND
WIRE
Preparation Step E.
Align the motor cover to
allow the four 8-32 X
3
/
8
″
(4) Phillips counter-
sunk screws to be installed.
Hand
tighten securely
MOTOR
COVER
MOTOR WIRES
&
DOWNROD
GROUND
PHILLIPS
COUNTERSUNK
SCREW
HOUSE WIRING
&
CROSSBAR
GROUND
CANOPY
CAUTION: Failure to properly tighten the
downrod could result in the fan falling.
CAUTION: Failure to properly tighten
the downrod in the motor coupling and
securely tightening the locking bolt
could result in the fan falling during
normal operation!
N
OUVELLE
™
Summary of Contents for Nouvelle
Page 1: ...NOUVELLE OWNER S MANUAL...
