U-section
The blade is fed from corner to corner.
Aluminium / copper
The machine must always be equipped with
the lubricating device, to be used when cutting
all kinds of aluminium and copper.
Shaped plate
The plate must always rest on three mounts,
with one on either side of the cut.
Pipe
The blade is fed through the object until it
reaches the lower edge, angled as it goes so
that the blade hits the material at an angle of
90°.
Spiral tube and longitudinal cutting
Feed the blade through the material, so that
the blade only protrudes through approx.
10mm, do not drive it as far as the blades en-
tire cutting edge. Then start to feed the blade
forwards or backwards.
Thin plate
Only feed the blade down approx. 10mm. then
start cutting.
The blade cover guard is fixed to protect the
operator from chips. When the blades rotates,
the chip flow comes our in both direction,
which must be observed.
Summary of Contents for DBS900
Page 10: ......
