44
10.3.2 Display brightness setting
It is possible to set the dimming of the display brightness when in standby mode.
a) Use the arrow keys to go to the set-up menu and press the
key;
b) Select the password "7" with the
key and confirm with the
key;
c) Scroll with the
key and select the sub-menu
[11]
and confirm with the
key;
d) Use the
and keys to set the desired brightness value (
OFF, 1 ... 5
) and confirm with the
key.
10.3.3 Display mode setting
It is possible to set what should be shown on the display when the latter is in standby mode
a) Use the arrow keys to go to the set-up menu and press the
key;
b) Select the password “7” with the
key and confirm with the
key;
c) Scroll with the
key and select the sub-menu
[12]
and confirm with the
key;
d) Set one of the following values with the
and keys:
“
OFF
”
•
The display will remain fixed on the last display operated by the user;
“
1
”
• All the operating parameters will be displayed cyclically;
“
2
”
• The temperature is displayed (detected by the room probe)
“
3
”
• The current time is displayed
“
4
”
•
The autonomy is displayed in hours before having to refill the tank, if the refuelling function
has been enabled.
e) Press the key
to confirm the set data.
10.3.4 Volume setting
Set the volume level of the buzzer, according to your requirements:
a) Use the arrow keys to go to the set-up menu and press the
key;
b) Select the password “7” with the
key and confirm with the
key;
c) scroll with the key and select the submenu
[13]
and confirm with the
key;
d) Use the and keys to set the desired volume level (
OFF,1 ... 5
) and confirm with the
key.
10.3.5 Fuel optimisation
Excellent fuel depends on different factors (type of installation, operating and maintenance conditions, type of
pellets, etc.)
Generally speaking, if at the end of combustion, there is a lot of residue in the burn pot, you should change the
combustion configuration (by increasing the value) until you find the best solution.
a) Use the arrow keys to go to the set-up menu and press the
key;
b) Select the password “
7
” with the
key and confirm with the
key;
c) Scroll with the key and select the submenu
[14]
and confirm with the
key;
d) Set one of the following values with the
and keys:
“
1
”
“
2
”
“
3
”
e) Press the key
to confirm the set data.
004778330 - 16/07/2020
Summary of Contents for LEONARDO 8ET
