35
|
P a g e
cascadesciences.com
|
Tel. 503 847-9047
OPERATION
L
AUNCH A
H
EATING
P
ROFILE
The oven can be run in a timed steady-state heating profile at the current temperature setpoint.
Allow the oven to come up to temperature prior to launching a profile. See the
on page 33 for how to set the length of the profile.
Note:
While the Timer system is on, the oven will
not
heat unless a profile is running.
End of Procedure
1.
Turn on the Timer System
Push to
ON ( I )
Set Timer
1 Hour, 55 Minute Profile
•
The
Timer Display
will illuminate, showing the previously programmed
profile duration.
•
The oven will cease heating.
2.
Launch the current profile
Press
and Hold
Set Timer
•
The Timer Display will start counting down.
•
The oven will resume heating.
Optional: Pausing a running profile
Push
•
The oven will cease heating until the profile is restarted, reset, or the
Timer system is turned off.
•
To restart the profile where it left off, press the
Start/Stop
“T” button
again.
3.
The oven ceases heating upon reaching “00:00”
Set Timer
Profile Complete
•
To resume manual heating place the
Timer Switch
in the OFF ( O ) position.
•
To launch another profile, press the “//”
Reset
button and enter a new
profile, or allow the previous profile to reset automatically after 5
seconds.
TIMER ACTIVATED
Summary of Contents for CDO-5-2
