47
|
P a g e
cascadesciences.com
|
Tel. 503 847-9047
USER MAINTENANCE
Warning
:
Disconnect this unit from its power supply prior to performing maintenance or services.
Avertissement
:
Débranchez cet appareil de son alimentation électrique avant d'effectuer la maintenance
ou les services.
C
LEANING AND
D
ISINFECTING
If a hazardous material or substance has spilled in the oven, immediately initiate your site’s
Hazardous Material Spill Containment protocol. Contact your local Site Safety Officer and follow
instructions per the site policy and procedures.
•
Periodic cleaning is required.
•
Do not use spray on cleaners or disinfectants. These can leak through openings and coat
electrical components.
•
Do not use cleaners or disinfectants that contain solvents capable of harming paint coatings
or stainless steel surfaces.
Do not use chlorine-based bleaches or abrasives; these will
damage the chamber liner.
•
Consult with the manufacturer or their agent if you have any doubts about the compatibility
of decontamination or cleaning agents with the parts of the equipment or with material
contained in it.
Warning
: Exercise caution if cleaning the unit with alcohol or flammable cleaners. Always allow the
unit to cool down to room temperature prior to cleaning and make sure all cleaning agents have
evaporated or otherwise been completely removed prior to putting the unit back into service.
Avertissement:
Soyez prudent lorsque vous nettoyez l'appareil avec de l'alcool ou des produits de
nettoyage inflammables. Laissez toujours refroidir l'appareil à la température ambiante avant le
nettoyage et assurez-vous que tous les produits de nettoyage se sont évaporés ou ont été
complètement enlevés avant de remettre l'appareil en service.
Cleaning
1. Disconnect the unit from its power supply.
2. Remove any removable chamber accessory items, such as shelving, if present.
3. Use 99% isopropyl alcohol to clean chamber surfaces and shelving. Apply using lint-free wipes.
4. Take special care when cleaning around temperature sensor probes. Do not clean the probes.
5. Clean all removable accessories and components.
6. Verify the cleaning alcohol has evaporated completely from all chamber surfaces and
accessories prior to reconnecting the unit to its power source.
Summary of Contents for CVO-2
