INSTALLATION
7
6914838 EN
Integral attachment should be
installed in the mast per OEM
specifications and procedures.
IMPORTANT:
Integral attachment installation is an OEM
or dealer responsibility. Some of the following steps may
or may not be required, but are shown for reference. Refer
to the appropriate service manual for service and repair
procedures.
WARNING
: Check the attachment weight
(located on the nameplate) to make sure the
overhead hoist and chains or straps are at
least the rated capacity of the attachment.
Attachment Installation
1
FP0726.eps
2
Flush supply hoses
A
Connect supply hoses to supply terminals
and connect together using union fittings as
shown.
B
Operate auxiliary valves for 30 sec.
C
Remove union fittings.
Install supply hoses
3
Fittings are male No. 8 JIC 37°.
Sideshift
Left
Sideshift
Right
IN0010.eps
IN0014.eps
80R
100R
IN0029.eps
Sideshift
Left
Sideshift
Right
Close
Forks
(if equipped)
Open
Forks
(if equipped)
Close
Forks
(if equipped)
Open
Forks
(if equipped)
Summary of Contents for 100R
Page 17: ...Blank...
