Cascade D Series, Operator'S Manual

- 12 -

安全操作和维护

S

AFE OPERATION AND MAINTENANCE

(OSHA REGULATIONS)

(6) Extreme care shall be used when tilting the load forward or backward, partially when high tiering. Tilting forward with load 

engaging means elevated shall be prohibited except to pick up a load. An elevated load shall not be tilted forward except when the load 

is in a deposit position over a rack or stack. When stacking or tiering, only enough backward tilt to stabilize the load shall be used.

(p) Operation of the Truck

(1) If at any time a poweredindustrial truck is found to be in need of repair, defective, or in any way unsafe, the truck shall be taken 

out of service until it has been restored to safe operating condition.

(q) Maintenance of Industrial Trucks

(1) Any powered-operated industrial truck not in safe operating condition shall be removed from service. All repairs shall be made 

by authorized personnel.

(5) All parts of any such industrial truck requiring replacement shall be replaced only by parts equivalent as to safety with those 

used in the original design.

(6)Industrial trucks shall not be altered so that the relative positions of the various parts are different from what they were 

when originally received from the manufacturer, nor shall they be altered either by the addition of extra parts not provided by the 

manufacturer or by the elimination of any parts. Additional counter-weighting of fork trucks shall not be done unless approve by the 

truck manufacturer.

(7) Industrial trucks shall be examined before being placed in service and shall not be placed in service if the examination shows 

any condition adversely affecting the safety of the vehicle. Such examinations shall be made at least daily. When industrial trucks 

are used on a round-the-clock basis, they shall be examined after each shift. Defects when found shall be immediately reported and 

corrected.