10
sAfety
GENERAL SAFETY INFORMATION
Do not operate unit if damaged during shipping, handling or use. Damage
may result in bursting and cause injury or property damage.
Since the air compressor and other components (filters, lubricators,
hoses, etc.) used, make up a high pressure pumping system, the
following safety precautions must be observed at all times:
1. Read all manuals included with this product carefully. Be thoroughly
familiar with the controls and the proper use of the equipment.
2. Follow all local electrical and safety codes
3. Only persons well acquainted with these rules of safe operation
should be allowed to use the compressor.
4. Keep visitors away and do not allow children in the work area.
5. Wear safety glasses and use hearing protection when operating the
pump or unit.
6. Do not stand on or use any part of the unit as a handhold.
7. Before each use, inspect the compressor system and electrical
components for signs of damage, deterioration, weakness, or
leakage. Repair or replace defective items before using.
8. Check all fasteners at frequent intervals and tighten if needed.
9. Keep fingers away from a running compressor; fast moving and hot
parts will cause injury and/or burns.
10. If the equipment starts to vibrate in an abnormal manner, STOP
the engine/motor and check immediately for the cause. Vibration is
generally a warning of trouble.
11. To reduce the risk of fire, keep engine/motor exterior free of
oil, solvent, or excessive grease. Never remove or attempt to
adjust safety valve. Keep safety valve free from paint and other
accumulations.
12. Never attempt to repair or modify a tank. Welding, drilling or any other
modification will weaken the tank resulting in damage from rupture or
explosion. Always replace worn or damaged tanks. Drain liquid from
tank daily.
13. Tanks rust from moisture build-up, which weakens the tank. Make
sure to drain tank daily and inspect periodically for unsafe conditions
such as rust formation and corrosion.
14. Fast moving air will stir up dust and debris which may be harmful.
Release air slowly when draining moisture or depressurizing the
compressor system.
15. Do not attempt to open/drain the air tank when it contains more than
10 PSI of pressure. Remove excess pressure with an air tool before
opening the drain valve.
16. Ensure that nothing is plugged in to the generator before turning the
engine on.
