INTRODUCTION
Engine cooling system - Basic instructions
Farmall® 100V With cab
NA
Farmall® 100V Without cab
NA
Farmall® 110V With cab [ZGLL03383 - ]
NA
Farmall® 110V Without cab [ZGLL03058 - ]
NA
Farmall® 80V With cab [ZGLL03152 - ]
NA
Farmall® 80V Without cab [ZGLL03079 - ]
NA
Farmall® 90V With cab
NA
Farmall® 90V Without cab
NA
Your cooling system is factory fill with
CASE IH AKCELA ACTIFULL™ OT EXTENDED LIFE COOLANT
, an Organic
Acid Technology (OAT) coolant solution. You can easily identify
CASE IH AKCELA ACTIFULL™ OT EXTENDED
LIFE COOLANT
by its yellow color. You should never mix the coolant types.
The decal shown is located near the fill point of the cooling
system whenever the factory fill is
CASE IH AKCELA AC-
TIFULL™ OT EXTENDED LIFE COOLANT
. This decal is
available in three different sizes. See the table below for
the associated part numbers.
CNH Industrial part
number
Size
47757330
50 mm
x
50 mm
47757331
75 mm
x
75 mm
47757332
100 mm
x
100 mm
The coolant solution used must meet the following CNH
Industrial material specifications for either coolant type:
•
MAT3624
for OAT coolant
•
MAT3620
for conventional coolant
47757330
1
NOTICE:
NEVER mix OAT coolant with conventional coolant. Under no circumstances should you top off a cooling
system with only water. You can use a refractometer to check the concentration level. You should not use Sup-
plemental Coolant Additives (SCA) when using
CASE IH AKCELA ACTIFULL™ OT EXTENDED LIFE COOLANT
.
Change the coolant solution at the recommended change interval.
If you need to change a machine from OAT coolant to conventional coolant or vice versa, you should follow the
“Changing coolant types” procedure below to attain the full benefit of the coolant.
Changing coolant types
To change coolant from OAT coolant to conventional coolant (or vice versa):
1. Empty the engine cooling system by draining the coolant into a suitable container.
2. Fill the system with clean water.
3. Start the engine and run the engine for at least
30 min
.
NOTE:
Make sure that you activate the heating system (if equipped) to circulate fluid through the heater core.
4. Repeat Steps 1 to 3 for a total of two washes.
5. Fill the system with conventional coolant (or OAT coolant).
6. Operate the engine until it is warm. Inspect the machine for leaks.
7. If you are changing to OAT coolant, then attach the decal (CNH Industrial part number 47757330) to indicate the
use of OAT coolant in the cooling system.
51430129 15/12/2017
13
Summary of Contents for FARMALL 100N
Page 9: ...51430129 15 12 2017 Find manuals at https best manuals com...
Page 10: ...INTRODUCTION 51430129 15 12 2017 1 Find manuals at https best manuals com...
Page 43: ...INTRODUCTION 51430129 15 12 2017 34...
Page 51: ...This as a preview PDF file from best manuals com Download full PDF manual at best manuals com...
