INTRODUCTION
Before leaving the tractor:
1. Park tractor on a firm level surface.
2. Put all controls in neutral or park lock position.
3. Engage park brake. Use wheel chocks if required.
4. Lower all hydraulic equipment — Implements, header, etc.
5. Turn off engine and remove key.
When, due to exceptional circumstances, you would decide to keep the engine running after leaving the operator’s
station, then the following precautions must be followed:
1. Bring the engine to low idle speed.
2. Disengage all drive systems.
3.
WARNING
Some components may continue to run down after you disengage drive systems.
Make sure all drive systems are fully disengaged.
Failure to comply could result in death or serious injury.
W0113A
Shift the transmission into neutral.
4. Apply the parking brake.
Using the tractor
1.
Select the most suitable wheel setting for the work in hand, i.e.: the setting that provides the best stability.
2.
Depress the speed control pedal slowly: if engaged too quickly, especially when the tractor is getting out of a
hole, ditch or operating on muddy ground or steep slopes, the tractor may overturn.
Release the speed control pedal immediately if front wheels begin to lift.
3.
When traveling downhill, keep the tractor in gear. Never place shuttle shift lever in the neutral position.
4.
When the tractor is moving, the operator must remain correctly seated in the driving position.
5.
Never get on or off the tractor while in movement.
6.
When using the brakes, press the pedal down slowly.
7.
Avoid taking turns at high speeds.
8.
Always use the tractor at a speed that will guarantee safe operation on the type of land being worked. When
working on uneven ground, use maximum care to ensure proper stability.
9.
If you have to work with the tractor on a gradient, for example on hillsides, drive at moderate speed especially
when taking turns.
10. Proceed with maximum caution when working with the wheels near the edge of ditches or slopes.
11. When driving on public highways, observe the Highway Code.
General maintenance safety
Keep area used for servicing the tractor clean and dry. Clean up spilled fluids.
Service tractor on a firm level surface.
Install guards and shields after servicing the tractor.
Close all access doors and install all panels after servicing the tractor.
Do not attempt to clean, lubricate, clear obstructions or make adjustments to the tractor while it is in motion or while
the engine is running.
Always make sure working area is clear of tools, parts, other persons and pets before you start operating the tractor.
47941906 16/03/2016
17
Summary of Contents for FARMALL 40C
Page 8: ...INTRODUCTION 47941906 16 03 2016 1 Find manuals at https best manuals com...
Page 12: ...INTRODUCTION Safety rules Farmall 40C NA Farmall 50C NA BT09A213 1 47941906 16 03 2016 5...
Page 51: ...This as a preview PDF file from best manuals com Download full PDF manual at best manuals com...
