DISTRIBUTION SYSTEMS - PRIMARY HYDRAULIC POWER SYSTEM
Hydraulic pump - Remove (A.10.A.20 - F.10.A.10)
435, 445, 445CT
1.
Loosen and remove the mounting bolts and washers
for the
fl
oor plate and the cover. Remove the
fl
oor
plate and the cover to gain access to the hydraulic
pump.
BD04C141x
1
2.
Place a shop towel under the gear pump.
3.
Remove the cap from the hydraulic reservoir.
CAS1871
4.
Connect a vacuum pump to the hydraulic reservoir.
CAS10192
5.
Reservoir - Apply vacuum (A.10.A.22 - F.35.A.50)
Start the vacuum pump.
6.
Tag and disconnect the hose from the
fi
tting at the
suction port of the gear pump.
BD04C141x
2
7.
Install a plug in the hose and a cap on the
fi
tting.
8.
Tag and disconnect the hose from the
fi
tting at the
pressure port of the gear pump.
9.
Install a plug in the hose and a cap on the
fi
tting.
10.
Stop the vacuum pump.
1 04/05/2005
A.10.A / 32
Summary of Contents for 435
