5 - TRANSPORT OPERATIONS
Tow procedure - engine runs
1. Engage the parking brake.
2. Block the wheels with wheel chocks.
3. Place the transmission in neutral.
4. Place the direction control lever in neutral.
5. Place the 4WD switch in the disengaged position, if equipped.
6. Raise the loader bucket and rear attachment off the ground.
7. Attach a rigid drawbar to the disabled machine.
8. Attach the rigid drawbar to the towing machine. Make sure the towing machine has enough power and braking
ability to move and stop both machines.
9.
Remove the wheel chocks.
10. Release the parking brake. If the parking brake will not disengage (for any reason), manually disengage the
parking brake. Refer to page
7-102
.
11. Tow the disabled machine, the maximum tow speed is
2.4 km/h
(
1.5 mph
).
Tow procedure - engine does not run
1. Block the wheels with wheel chocks.
2. Place the transmission in neutral.
3. Place the direction control lever in neutral.
4. Place the 4WD switch in the disengaged position, if equipped.
5. Attach a rigid drawbar to the disabled machine.
6. Attach the rigid drawbar to the towing machine. Make sure the towing machine has enough power and braking
ability to move and stop both machines.
7. Disconnect the rear drive shaft (two wheel drive machines) or both the front and rear drive shafts (four wheel drive
machines).
NOTE:
The machine is equipped with Spring Applied Hydraulic Released (SAHR) parking brake integrated in the
transmission. The parking brake remains engaged if the engine is disabled. Manual disengagement of the parking
brake is not required for towing with the drive shafts removed.
8. Remove the wheel chocks.
9. Tow the disabled machine, the maximum tow speed is
2.4 km/h
(
1.5 mph
).
5-4
Summary of Contents for 570NXT
