3 - CONTROLS/INSTRUMENTS
Rear hitch controls
Three point hitch mode control switch, if
equipped
This is a three position rocker switch. It is recommended
when operating the three point hitch lift circuit in the laser
mode that the Flow Control Regulator be at the
11 l/min
(
3 US gpm
) setting.
A.
LASER
mode - Push the front of the rocker switch to
put the three point hitch lift circuit in the Laser mode.
In this mode the laser controls the lift circuit. Use of
the lift control lever will override the laser mode.
B.
FLOAT UP
mode - Put the rocker switch the center
position to put the three point hitch lift circuit in the
Float Up mode. Position the box scraper at the desired
position. Move the rocker switch to Float Up. Move
the lift control to the float position. In this mode the
three point hitch will not go any lower but will float up
as required and then return to the original position.
C.
NORM
mode - Push the rear of the rocker switch to
put the three point hitch lift circuit in the Normal mode.
In this mode the three point hitch cannot be lowered
when the lift control is in the neutral position, or if the
key switch is in the OFF position.
RAPH12UTL0023AA
1
Three point hitch control levers, if equipped
1.
LIFT
- Controls the height of the rear attachment.
2.
PITCH
- Controls the front and rear pitch of the attach-
ment.
3.
TILT
- Controls the tilt on the right side of the attach-
ment.
4.
AUX
- Controls auxiliary functions or the optional Left
Tilt of the attachment.
NOTE:
If the machine is equipped with Optional Left
Tilt the first auxiliary control lever is the Left Hand Tilt
and the second auxiliary control lever is the Scarifier.
If the machine is not equipped with Optional Left Tilt
the first auxiliary control lever is the Scarifier.
5.
AUX
- Controls auxiliary functions or the Scarifier
when the machine is equipped with the optional Left
Tilt function.
RAPH12UTL0022AA
2
3-16
Summary of Contents for 570NXT
