7 - MAINTENANCE
Front axle breather
Clean the front axle breather every 250 hours of operation.
If you operate the machine in severe conditions, clean it
more frequently.
The front axle breather is located on the left side of the front
axle.
1.
Remove dirt and debris from the area around the
breather and clean with solvent.
2.
CAUTION
Eye injury hazard!
Wear protective goggles when using
compressed air.
Failure to comply could result in minor or
moderate injury.
C0035A
Blow dry the area with compressed air.
3.
Spin the top cap to ensue that it is free to turn.
RCPH10TLB058AAF
1
Front axle drive shaft
Grease the front slip spline every 250 hours of operation.
Use
T
UTELA
M
ULTI
-
PURPOSE
EP
GREASE
251H, GR-9
.
RAIL11TLB0010AA
1
7-63
Summary of Contents for 570NXT
