3 - CONTROLS/INSTRUMENTS
Automatic:
This button
(2)
is used for automatic adjustment of the
volume, the direction of flow and starting or stopping of
the air conditioning.
“Auto”
will appear on the display
screen
(9)
. In automatic mode, the only possible manual
adjustment is to the temperature
(3)
.
If a control other than the temperature control is operated,
the automatic mode will be cancelled and
“Auto”
will dis-
appear from the display
(9)
. To stop the system, press
buttons
(1)
or
(2)
.
8TWEZ7-001
10
To obtain hot or cold air quickly:
Cold air: Quit the automatic mode by pressing button
(2)
then press button
(3)
down to the minimum temperature
of
18 °C
(
64.4 °F
). Ventilation will be at maximum and cold
air flow will come from the front.
Hot air: Quit the automatic mode by pressing button
(2)
then press button
(3A)
up to the maximum temperature
of
32 °C
(
89.6 °F
). Ventilation will be at maximum and the
flow of hot air will come from the rear at foot level.
NOTICE:
To ensure correct functioning and full effective-
ness of the air conditioning system, it must be run at least
once a week, even if only for a short time. For mainte-
nance of the air conditioning circuit components, refer to
page
6-73
.
8TWEZ7-002
11
3-55
Summary of Contents for CX145C SR
