3 - CONTROLS/INSTRUMENTS
6.
Select the filling method using the selector switch lo-
cated to the right of the filling pump.
“Auto”
mode, the pump stops filling automatically
and the audible alarm sounds when the fuel tank is
full.
“Manual”
mode, monitor the filling by means of the
reservoir gauge and stop when necessary.
7.
Turn the switch located on the pump to the
“On”
po-
sition (start). Filling begins.
NOTE:
It is possible to stop filling at any time for
any reason (empty drum, for example) by turning the
switch to the
“Off”
position.
8.
When the fuel tank is full, turn the switch and the
selector switch to the
“Off”
position (stopped). In
“Auto”
mode, the audible alarm device will cease to
function.
9.
Run the pump for a few moments to empty the pipe
outside the drum. Clean and replace the inlet pipe in
the front storage compartment.
10. Refit the fuel tank filler cap.
11. Place the ignition key in
“Off”
position.
398C7463
4
NOTE:
The pump is equipped with a
10 A
fuse.
5F5DAB92
5
3-80
Summary of Contents for CX145C SR
