4 - OPERATING INSTRUCTIONS
4. After entering all 4 digits, press the menu button
(5)
to
register the password code. The screen returns to the
normal display.
ATTENTION:
Be sure to keep a record of the code num-
ber.
Using the anti-theft protection
The anti-theft protection has to be activated when you are
shutting down the engine. Turn the ignition key from
“On”
to
“Off”
for about 2 seconds at a time until the audible
alarm device sounds. The icon of the anti-theft protection
is displayed on the screen, the anti-theft protection is acti-
vated, now the access code will have to be entered when
starting the engine.
You are not obliged to activate the anti-theft protection. In
that case all you have to do is to turn the ignition key to
the
“Off”
position when shutting down the engine. In that
configuration, it will not be necessary to enter the code
when starting the engine.
12K2R4-002Z
3
Entering the access code
If the anti-theft protection was activated the last time the
engine was shut down, it will then be necessary to enter
the access code before being able start it again.
AZ8P3X-001
4
1. Turn the ignition key to the
“On”
position.
2. The message "Password?" and four boxes will appear
on the display screen.
3. Enter the code in the same manner as during registra-
tion. Once all four digits have been entered, validate
with the button
(5)
.
AZ8P3X-003
5
4-5
Summary of Contents for CX145C SR
