5 - TRANSPORT OPERATIONS
3. Select low travel speed, indicator lamp off. A "turtle"
is displayed on the monitor.
4. Raise the dozer blade (if equipped).
UUDO6A-003
3
5. (Machine with attachment)
Place the machine in line with the trailer, with the travel
reduction gears towards the access ramps. Raise the
attachment and bring it to about twenty centimetres
above the bed of the trailer.
ATTENTION:
In this position, the travel and steering con-
trols are reversed.
NOTE:
If the machine is equipped with a dozer blade, it is
preferable to load the machine with the dozer blade facing
the trailer to prevent interference with the attachment.
UUDO6A-004
4
5. (Machine without attachment)
Place the machine in line with the trailer, with the travel
reduction gears towards the access ramps.
ATTENTION:
In this position, the travel and steering con-
trols are reversed.
UUDO6A-005
5
6. (Machine with attachment)
When the machine is completely on the trailer, swing
the upperstructure to bring the attachment round to the
ramp end.
UUDO6A-006
6
5-3
Summary of Contents for CX145C SR
