6 - MAINTENANCE
Greasing the turntable teeth
Grease capacity:
9.9 kg
(
21.8 lb
)
Type of grease: (refer to page
6-5
Every 500 hours
Remove the inspection cover
(1)
and visually check the
condition of the gear surface and for any damage.
If the gear surface is not well greased, add grease.
If the grease is white due to moisture content, etc. replace
it with new grease.
5ZISAG-003
26
If the presence of water is detected, remove the plug
(2)
and drain off the water.
1. Remove the protective panel from the lower central
area.
2. Remove plug
(2)
.
3. Discharge the water or contaminated grease.
4. Install plug
(2)
.
5. Insert new grease through the port and install the in-
spection cover
(1)
.
5ZISAG-008
27
6-20
Summary of Contents for CX145C SR
