6 - MAINTENANCE
9. Open the valve
(1)
on the fuel tank line and open the
valve
(2)
on the engine line.
7952FD88
12
Fuel system air bleed
NOTICE:
When the fuel tank has been emptied after re-
placement and/or draining water of the pre-fuel filter or the
fuel filter
(4)
has been carried out, be sure to bleed air as
this may prevent fuel flow because of air entering inside.
60A45B56
13
1. Place a receiving container under the end of fuel drain
hose.
2. Set each cock of
(A)
,
(B)
and
(C)
as follows.
Cock
(A)
(fuel tank): Open
Cock
(B)
(engine): Close
Cock
(C)
(drain): Open
75C1814E
14
3. Loosen the air bleeding plug
(2)
on fuel filter. Do not
loosen the air bleeding plug of the pre fuel filter.
4. Insert the key into the ignition switch and turn the key to
the
“On”
position. Electromagnet feed pump operates
by this.
ATTENTION:
Do not turn
“On”
the ignition key for
more than 5 minutes unless bleeding air has been
completed. Otherwise, this may cause breakdown of
the electromagnetic fuel pump.
5. Turn the handle of the feed pump
(1)
to the left and it
will spring up due to the spring inside the handle.
A0178EC5
15
6-34
Summary of Contents for CX145C SR
