2 - SAFETY INFORMATION
Hand signals
When operating the machine, never attempt to carry out
tasks calling for fine control or working in areas where vis-
ibility is poor or impaired without seeking the assistance
of a signalman. Make perfectly sure that you and the sig-
nalman understand the signals to be used.
The following is a compilation of the Hand Signals to be
used when a flagman is required for Excavator Operation.
All personnel associated with the operation of the exca-
vator should know these signals and their meaning before
attempting to operate this machine.
Raise load vertically
DC04E038
1
Face machine operatorr, raise right forearm vertical,
with index finger pointing up and move hand in a small
circular motion.
Lower load vertically
DC04E039
2
Face machine operator, extend right arm down, point
index finger down and move hand in small circular
motion.
Move load horizontally
DC08E040
3
Face machine operator, extend right arm toward
operator with hand facing operator and move hand in
direction of movement required.
Move load out horizontally
DC08E041
4
Face machine operator, extend right arm toward
operator with back of hand facing operator and move
hand in direction of movement required.
2-28
Summary of Contents for CX145C SR
