3 - CONTROLS/INSTRUMENTS
Seat belt
WARNING
Equipment failure could cause accident or in-
jury!
Always fasten seat belt securely before op-
erating the machine. Inspect seat belt parts
for wear and/or damage. To ensure operator
safety, replace any and all damaged parts of
the seat belt prior to operation.
Failure to comply could result in death or se-
rious injury.
W0046A
Sit comfortably in the operator’s seat, pull out a long sec-
tion of belt and engage it in the fastening system
(9)
.
NOTE:
If the section of belt pulled out is not long enough,
release it, so it rolls up and then pull it out again.
To release the seat belt, press down on the releasing lever
(9)
.
ATTENTION:
Inspect the seat belt. Make sure that it is
not damaged, that the mounting screws are correctly tight-
ened and replace any defective parts.
The seat belt must be kept clean. Use only soap and
water to clean the belt, do not use bleach or dyes.
D92B54EA
9
3-8
Summary of Contents for CX145C SR
