3 - CONTROLS/INSTRUMENTS
Displayed when the wiper operation is switched.
1st speed
2nd speed
Stop
• Idle mode
Displayed when the engine auto idling and idle stop
operations are switched.
Auto idling
Auto idle stop
Auto idling and idle stop
• Pre-heating (glowing)
12. Eco gauge
The number of indicators on this gauge increases
when the operating state is energy-saving operation.
If high-load operations are performed, the number of
gauge indicators decreases.
The state of energy-saving operations is indicated.
• No mechanical abnormalities will occur even if the
number of gauge indicators decreases. However, to
help conserve the environment, try to perform en-
ergy-saving operations within the green range, so
long as doing so does not hinder work.
Key points for energy-saving operations
• Try to use
H
mode or
A
mode instead of
SP
mode.
• Avoid sharp lever operations.
• Avoid high load and relief operations.
• Use auto idle and one-touch idle.
Also, use idle stop to stop unnecessary idling.
Ask your CASE CONSTRUCTION Dealer about how
to turn the eco gauge display
“On”
and
“Off”
.
13. Auto pressure boost icon
Displayed when the maximum output
state is entered automatically for the at-
tachment.
14. Mute icon
Displayed when the radio volume is
muted.
15. Hour meter
The hour meter displays the engine operation time in
units of 0.1 hr. (6 min.).
16.
DPD
(Diesel Particulate Diffuser) gauge
Indicates the state of the
DPD
filter. When 5 gauge
indicators are lit,
DPD
regeneration is performed.
(Refer to page
3-37
17. Display during
DPD
(Diesel Particulate Diffuser) re-
generation
During automatic regeneration: Green
During manual regeneration: Yellow
Refer to page
3-37
for details.
18. Fuel economy display and
DTC
(Diagnostic Trouble
Code) display
The time/fuel consumption at that time “gph” is dis-
played.
The
DTC
(Diagnostic Trouble Code) is displayed
here.
19. Message screens
MUC8LU-042Z
4
This section of the display screen shows information
icons and messages that change according to the set
application of the machine.
An alarm also sounds when some of these messages
are displayed.
The following section describes the icons, mes-
sages, and their corresponding explanations.
NOTICE:
If a message is displayed, perform mainte-
nance according to the message.
ATTENTION:
If the message is still displayed after
maintenance, consult your CASE CONSTRUCTION
Dealer.
NOTE:
The language of the displayed messages can
be changed, consult your CASE CONSTRUCTION
Dealer.
• Low oil pressure
3-21
Summary of Contents for CX145C SR
