3 - CONTROLS/INSTRUMENTS
RIGHT-HAND SIDE CONTROLS
Right-hand control arm
UZS15G-001B
1
1.
Ignition switch
This switch has four positions,
“On”
(contact),
“Start”
(engine ignition),
“Off”
(engine shut-down)
and
“Acc”
(accessory current supply).
NOTICE:
When the ignition key is in
“On”
(contact)
position, if the anti-theft protection has been pro-
grammed, then it will be necessary to enter the code.
The message "Password" will be displayed. (Refer
to page
4-4
NOTE:
This key is also used to lock the cab door,
the engine hood, the front storage compartment, the
side doors and the fuel tank cap.
2.
Engine acceleration button and working mode selec-
tor
This button enables an increase or reduction in the
engine speed.
This button is coupled with the three working mode
selector.
Mode
“A”
(automatic) when the energy output has
priority.
In this mode, the balance between the speed and
energy output is controlled for each movement of the
controls.
Mode
“H”
for difficult excavation work or if the load
increases, and mode
“SP”
when the output has pri-
ority.
Each selected mode
(A
,
H
or
SP)
is displayed on the
screen.
NOTE:
To select the
“SP”
mode, operate the index-
ing pin while rotating the acceleration button to the
right.
NOTE:
If there is no change in engine speed, press
and release the engine automatic idle speed selector.
3.
Engine idle speed selector
This control enables automatic engine idle without
operating the throttle button.
To select idle speed, press and release the control
for the engine automatically to go into idle speed;
the "Engine idling" icon will appear on the message
screens.
When the control is pressed and released once more
the engine will revert to its original speed and the icon
on the systems display panel will disappear.
4.
Arm angle adjustment lever
This lever is used to adjust the control arm tilt to suit
the operator.
Pull the lever to the right and hold it in this position,
tilt the control arm to the required position and then
release the lever.
ATTENTION:
The adjustment of the control arm
must be done with the engine stopped.
5.
Travel caution alarm switch
“Cont”
position the alarm sounds when the travel
controls are actuated.
“Auto off”
position, when the travel control are actu-
ated, the alarm sounds for 10 seconds and then stop.
6.
Option control (if equipped)
7.
Option control (if equipped)
8.
Cab radio
To operate the cab radio. (Refer to page
3-59
9.
Option control (if equipped)
10. Wiper switch
When the switch is pressed, the wiper moves.
11. Radio auxiliary input port
3-57
Summary of Contents for CX300C
