4 - OPERATING INSTRUCTIONS
STOPPING THE UNIT
Stopping the engine
1. Lower the attachment until it is resting on the ground.
2. Turn the engine throttle button
(1)
to low idle position
and let the engine run for 5 minutes or so.
NOTICE:
In cold weather, let the engine run for about 10
minutes at idle speed.
NOTICE:
Always let the engine run at idle before switch-
ing off completely, except in emergency situations.
3. Turn the ignition key
(2)
to the
“Off”
position.
NOTE:
To activate the anti-theft protection when stopping
the engine, (refer to page
4-4
NOTICE:
When the engine is to be shut down for a con-
siderable length of time, (refer to page
4-40
).
In the event of an emergency
QA348S-002
1
In the event of an emergency or if it is not possible to stop
the engine using the ignition key, press the emergency
shut-down switch on the left-hand control arm.
ATTENTION:
This switch should only be used in case of
an emergency. Do not use it on a day-to-day basis to stop
the engine.
A5FJZS-001A
2
4-13
Summary of Contents for CX300C
