6 - MAINTENANCE
Starting up after storage
WARNING
Unexpected machine movement!
Before starting the engine, make sure all controls are in the neutral position.
Failure to comply could result in death or serious injury.
W0311A
WARNING
Inhalation hazard! Risk to operators and bystanders.
Avoid running the engine in confined areas. Make sure there is adequate ventilation at all times.
Failure to comply could result in death or serious injury.
W0156A
1.
Drain the fuel tank, the pre-filter and the fuel filter,
replace the filter elements if necessary.
2.
Fill the fuel tank with suitable fuel. (Refer to page
6-5
).
3.
Install the batteries or reconnect the cable to the neg-
ative (-) terminal.
4.
Grease the machine thoroughly.
5.
Check the condition of the fan drive belt and replace
it if necessary.
6.
Check the condition of the air conditioning drive belt
and replace it if necessary.
7.
Check the cooling system level and add more coolant
if necessary.
8.
Check the engine oil level and add more oil if neces-
sary.
9.
Check the hydraulic fluid level and add more fluid if
necessary.
10.
Check the travel reduction gears and swing reduction
gear oil level and add more oil if necessary.
11.
Clean the cylinder rods.
12.
Unplug the air filter inlet and the exhaust pipe.
13.
Remove the "Do not operate" tag and start the en-
gine, following the starting up procedure.
14.
Check all the indicators and lamps carefully.
NOTICE:
Check the machine and the engine for leaks or for any parts that are broken, defective or missing.
6-89
Summary of Contents for CX300C
