4
CashConcepts
CCE 140
How to use the CCE 140
Please follow the below instructions for using the machine to receive an optimum detction result.
Connect the power supply with the outlet.
Connect now the power supply with the CCE 140 and switch on the unit by holding the ON-OFF
button pressed for 2 seconds.
The device will make a selftest after turning on and shows the software version display and also the
information “Ready…”
Insert the banknotes to be tested now one by one in the device.
Please note, that all banknotes have to be insert on the right side of the device as shown on
the pictures, if you don’t put them on the right side they might be recognized as
counterfeited. Not all banknotes can be checked in all 4 longitude directions as the Euro.
The security features are out of the sensor range when inserted in the wrong direction.
The banknotes are drawn in and checked, accepted notes are ejected according to setting in front or
behind.
Suspected counterfeit money is ejected in general forwards and you are informed about the suspicious note by a
warning tone. Also banknotes which were not inserted on the right side or in the correct direction will be ejected
as suspected.
Setting and function
Issue Direction
You have the selection at the CCE 140 that accepted banknotes are returned from the input tray or to eject from
the rear output shaft. Banknotes that are viewed by the device as counterfeit suspect, are generally thrown out by
the input shaft, along with an error message and a beep. By using the DIR button you can change the output
direction. The arrows on the left side of the display show the currently selected direction of ejection.
Print-Function
If you want to print the results of the test, hold the STA - button for about two seconds. The display then shows
the message "Print ....". After printing, the device automatically switches back to test mode. If the device should be
equipped with the optional serial number reading, the serial numbers of banknotes are printed together with the
counting result.