Other Settings
This section explains other watch settings you
can configure.
Button Operation Sound
Setting
Use the procedure below to enable or disable
the tone that sounds when you press a button.
1.
Enter the Timekeeping Mode.
l
2.
Hold down (A) for at least two seconds.
This displays the Timekeeping Mode
setting screen.
Pointer
3.
Use (A) and (C) to move the pointer to
[BEEP].
4.
Press (B).
5.
Use (A) and (C) to move the pointer to
[OPERATION].
6.
Press (B).
7.
Use (A) and (C) to move the pointer to
[ON] (enabled) or [OFF] (disabled).
8.
Press (B) to complete the setting
operation.
After the setting operation is complete,
[SETTING COMPLETED] will appear for
a few seconds, and then the BEEP
(sound) setting screen will re-appear.
●
is displayed in the Timekeeping
Mode while the operation tone is
disabled.
9.
Press (D) twice to exit the setting screen.
Configuring Notification
Sound Settings
You can use the procedure below to enable or
disable the notification sound.
1.
Enter the Timekeeping Mode.
l
2.
Hold down (A) for at least two seconds.
This displays the Timekeeping Mode
setting screen.
Pointer
3.
Use (A) and (C) to move the pointer to
[BEEP].
4.
Press (B).
5.
Use (A) and (C) to move the pointer to
[NOTIFICATION].
6.
Press (B).
7.
Use (A) and (C) to select a notification
sound ON/OFF setting.
[ALL ON]
Enables sound for all
notifications.
[USER]
Enables sound only for items
specified by you.
[ALL OFF]
Disables sound for all
notifications.
Note
●
The configuration of [USER]
notifications can be changed using G-
SHOCK MOVE.
8.
Press (B) to complete the setting
operation.
After the setting operation is complete,
[SETTING COMPLETED] will appear for
a few seconds, and then the BEEP
(sound) setting screen will re-appear.
●
is displayed in the Timekeeping
Mode while the notification tone is
disabled.
9.
Press (D) twice to exit the setting screen.
Configuring Vibration
Settings
In addition to operation sounds and
notification sounds, your watch also uses
vibration for alerts. You can use the procedure
below to enable or disable vibration.
●
The
icon is shown on the Timekeeping
Mode display while operation vibration or
notification vibration is enabled.
●
Configuring Operation Vibration
Settings
1.
Enter the Timekeeping Mode.
l
2.
Hold down (A) for at least two seconds.
This displays the Timekeeping Mode
setting screen.
Pointer
3.
Use (A) and (C) to move the pointer to
[VIBRATION].
4.
Press (B).
5.
Use (A) and (C) to move the pointer to
[OPERATION].
6.
Press (B).
7.
Use (A) and (C) to enable or disable
operation vibration.
[ON]
Enables operation vibration.
[OFF]
Disables operation vibration.
8.
Press (B).
After the setting operation is complete,
[SETTING COMPLETED] will appear for
a few seconds, and then the vibration
setting selection screen will re-appear.
9.
Press (D) twice to exit the setting screen.
Operation Guide 3482
29
