E-38
To configure countdown start time and auto-repeat settings
1. While the countdown start time is on the display in the
Countdown Timer Mode, hold down
A
for about three
seconds until the minute setting of the countdown start
time starts to flash. This is the setting mode.
•
If the countdown start time is not displayed, use the
procedure under “To use the countdown timer” (page
E-37) to display it.
2. Press
C
to move the flashing in the sequence shown
below, and select the setting you want to change.
Start Time
(Minutes)
Auto-Repeat
On/Off
C
3. Perform the following operations, depending on which setting currently is selected
on the display.
•
While the start time setting is flashing, use
D
(+) and
B
(–) to change it.
•
While the auto-repeat on/off setting (
0N
or
0FF
) is flashing on the display, press
D
to toggle auto-repeat on (
0N
) and off (
0FF
).
Start time (minutes)
Summary of Contents for 5054
Page 1: ...Module No 5054 MO0901 EB ...
