Timing the First and Second
Place Finishers
1.
Enter the Stopwatch Mode.
l
2.
Use the operations below to measure
elapsed time.
E
B
E
2nd Finisher*
1st Finisher*
Start
*
Displays the time of the first finisher.
●
Elapsed time is shown in 1/1000-
second units for the first hour of the
measurement session. After the first
hour, elapsed time is shown in 1/10-
second units.
Hours, minutes,
seconds, 1/10 seconds
Minutes, seconds,
1/1000 seconds
After first hour
First hour
3.
Press (B) to display the time of the second
place finisher.
4.
Press (B) to reset the stopwatch to all
zeros.
Timer
The timer counts down from a start time
specified by you. A beeper sounds when the
end of the countdown is reached.
●
The beeper is muted in the cases described
below.
ー
When battery power is low
Setting the Countdown Start
Time
The countdown start time can be set in 1-
second units up to 24 hours.
●
If a timer countdown operation is in
progress, reset the timer to its current start
time before performing this operation.
l
1.
Enter the Timer Mode.
l
2.
Hold down (A) for at least two seconds.
Release the button when the hour digits
start to flash.
This causes the hours digit to flash.
Hours
3.
Use (B) and (E) to change the timer hours
setting.
4.
Press (D).
This causes the minutes digits to flash.
Minutes
5.
Use (B) and (E) to change the minutes
setting.
6.
Press (D).
This causes the seconds digits to flash.
Seconds
7.
Use (B) and (E) to change the seconds
setting.
8.
Press (A) to exit the setting screen.
Note
●
You can also use G-SHOCK
Connected to configure timer settings.
Using the Timer
1.
Enter the Timer Mode.
l
2.
Use the operations below to perform a
timer operation.
E
E
E
(Time up)
Resume
Pause
(Countdown starts)
Start
●
A beeper will sound for 10 seconds to
let you know when the end of a
countdown is reached.
●
You can reset a paused countdown to
its start time, by pressing (B).
3.
Press any button to stop the tone.
Alarms and Hourly Time
Signal
The watch will beep when an alarm time is
reached. You can set up to five different
alarms. The hourly time signal causes the
watch to beep every hour on the hour.
●
The alarm sound is muted in the cases
described below.
ー
When battery power is low
ー
When watch is at Level 2 power saving
l
Operation Guide 5631
11
