●
Configuring the Summer Time Setting
1.
Y
Tap the “EDIFICE Connected” icon.
2.
X
Hold down (C) for at least three seconds
until [CNCT] starts to flash. Release the
button when the function hand moves to
e
.
When a connection is established
between the watch and phone, [CNCT]
will stop flashing.
●
If connection fails for some reason,
[ERR] will appear on the display
momentarily and then the watch will
return to the Timekeeping Mode.
Trying to connect
Connected
3.
Y
Perform the operation shown on the
phone screen to select a summer time
setting.
●
“Auto”
The watch switches between standard
time and summer time automatically.
●
“OFF”
The watch always indicates standard
time.
●
“ON”
The watch always indicates summer
time.
Note
●
While the summer time setting is
“Auto”, the watch will switch between
standard time and summer time
automatically. You do not need to
switch between standard time and
summer time manually. Even if you are
in an area that does not observe
summer time, you can leave the
watch’s summer time setting as “Auto”.
●
For information about summer time
periods, refer to the “Summer Time
Table” or EDIFICE Connected.
●
Swapping Your World Time and Home
Time
1.
Y
Tap the “EDIFICE Connected” icon.
2.
X
Hold down (C) for at least three seconds
until [CNCT] starts to flash. Release the
button when the function hand moves to
e
.
When a connection is established
between the watch and phone, [CNCT]
will stop flashing.
●
If connection fails for some reason,
[ERR] will appear on the display
momentarily and then the watch will
return to the Timekeeping Mode.
Trying to connect
Connected
3.
Y
Perform the operation shown on the
phone screen to swap your Home Time
with your World Time.
Note
●
Auto time adjustment does not work for
24 hours after swapping of the Home
Time and World Time.
Adjusting Hand Alignment
If the hands are out of alignment even though
auto time adjustment is being performed, use
EDIFICE Connected to adjust them.
1.
Y
Tap the “EDIFICE Connected” icon.
2.
X
Hold down (C) for at least three seconds
until [CNCT] starts to flash. Release the
button when the function hand moves to
e
.
When a connection is established
between the watch and phone, [CNCT]
will stop flashing.
●
If connection fails for some reason,
[ERR] will appear on the display
momentarily and then the watch will
return to the Timekeeping Mode.
Trying to connect
Connected
3.
Y
Perform the operation shown on the
phone screen to correct hand alignment.
Phone Finder
You can use phone finder to trigger a tone on
the phone to make it easy to find. The tone is
forced to sound even if the phone is in vibrate
mode.
Important!
●
Do not use this function in areas where
phone call tones are restricted.
●
The tone sounds at a high volume. Do
not use this function when listening to
phone output over earphones.
1.
X
If the watch is connected with a phone,
press any button to terminate the
connection.
Disconnected
Connected
Watch Operation Guide 5658
12
