— 16 —
4. Headphone check
1
Press “CONTROL” button.
* The confirmation chord of C4, E4 and G4 sounds.
2
Connect the headphone to the jack.
* “PART(R)” LED lights.
3
Remove the headphone from the jack.
* “PART(L)” LED lights.
4
Connect the tuning meter to the jack.
* “PART(R)” LED lights.
5
Press A4 key.
* Make sure that the tuning meter is set at 440
±
2 cents.
6
Remove the tuning meter from the jack.
* “PART(L)” LED lights.
5. MIDI IN/OUT check (If there is no MIDI cable, this check can be skipped)
1
Connect MIDI IN and MIDI OUT terminals with a MIDI cable.
2
Press “CONTROL” button.
* The confirmation chord of C4, E4 and G4 sounds.
* “PART(L)” LED lights.
3
Press “A4 KEY” button.
* The confirmation chord of C4, E4 and G4 sounds.
6. ROM version check
Version: 1.20
* LED should be in the following state.
USER_SONG LED:
Turn on
PART(L) LED:
Turn off
PART(R) LED:
Turn off
SPLIT LED:
Turn off
7. The diagnostic program ends.
Summary of Contents for Celviano AP-24
