— 20 —
F1
(YES)
* Pressing
AC
interrupts the send operation and
returns to the LINK Mode.
The following appears after the send operation is
complete.
* Press
AC
to return to the LINK Mode.
F1
(YES)
* Pressing
AC
interrupts the receive operation and
returns to the LINK Mode.
The following appears after the receive operation is
complete.
COMMUNICATION
COMPLETE
ALL DATA
PRESS [ AC ]
= = TRANSMITTING = =
ALL DATA
TO STOP : [ AC ]
COMMUNICATION
COMPLETE
ALL DATA
PRESS [ AC ]
= = RECEIVING = =
ALL DATA
TO STOP : [ AC ]
Warning!
Transferring data using ALL causes data in the applicable memory areas of the receiving unit to be
replaced by the received data. Make sure that you do not need the data stored in the receiving unit
before you start an operation using ALL.
11-5. Data Communications Precautions
Note the following precautions whenever you perform data communications.
• A TRANSMIT ERROR occurs whenever you try to send data to a receiving unit that is not yet
standing by to receive data. When this happens, press
AC
to clear the error and try again, after
setting up the receiving unit to receive data.
• A RECEIVING ERROR occurs whenever the receiving unit does not receive any data approxi-
mately six minutes after it is set up to receive data. When this happens, press
AC
to clear the
error.
• A TRANSMIT ERROR or RECEIVE ERROR occurs during data communications if the cable
becomes disconnected, if the parameters of the two units do not match, or if any other communi-
cations problem occurs. When this happens, press
AC
to clear the error and correct the problem
before trying data communications again. In this case, any data received before the problem
occurred is cleared from the receiving unit's memory.
• A MEMORY FULL operation occurs if the receiving unit memory becomes full during data com-
munications. When this happens, press
AC
to clear the error and delete unneeded data from the
receiving unit to make room for the new data, and then try again.
